Secutron MR-2900 Betreibershandbuch PDF herunterladen (Seite 15)

MR-2900 Operator’s Manual

a second screen including information from the database. You can start by looking at

either the last event (newest) or the first event (oldest). When viewing the events, scroll to

the next one using the <Right Arrow> or the previous one with the <Left Arrow>.

<Enter> will act as the last <Left> or <Right> arrow key pressed. <Up Arrow> and

<Down Arrow> will flip between pages of the event.

The screen of a single screen event shows:

Line 1: time, sequence number, and date

Line 2: Condition Code and Zone Number (see section 2.1)

Line 4: description of event (alarm, trouble, ground, restore, etc.)

The first screen of a two screen event shows:

Line 1: time, sequence number, and date

Line 2: Condition Code and Zone Number (see section 2.1)

Line 3: description of event (alarm, trouble, ground, restore, etc.)

Line 4: device type

The second screen shows:

Line 1: time, sequence number, and date

Lines 2 to 4: description from the database

• Program: Displays the Clock Menu. This menu has 2 options:

-- Date: View or change the date. The date is entered in MM.DD.YY format. Each section

of the date must be separated by a dot. Press <Enter> to accept date typed. <Clear>

will remove any digits typed. If no digits are displayed, <Clear> will return to the Clock

Menu. The date change will be recorded in the history.

-- Time: Change the time. The time is entered in HH.MM.SS format. Each section of the

time must be separated by a dot. All times are in 24 hour format. Press <Enter> to

accept time typed. <Clear> will remove any digits typed. If no digits are displayed,

<Clear> will return to the Clock Menu. The new time entered will be sent to all units on

the network, if any. A time change of greater than 5 minutes will be recorded in the

history.

• Passcode: Allows access to privileged functions. Enter the four digit passcode. A

passcode of zero removes all privileges. Asterisks are displayed instead of the numbers to

maintain security of the passcode. <Clear> will remove any digits typed. If no digits have

been typed, <Clear> will return to the Main Menu. The panel will beep once if a valid

passcode is entered or three times if an invalid passcode is entered. An invalid passcode

will not change the current privilege of the panel. Higher level passcodes timeout after two

hours and the panel reverts to Level 0.

The number at the end of the top line shows the current privilege level. The number at the

beginning of the second line is a sequence number. This number is required if special

higher level passcodes are needed. This number will change with each successful special

passcode entered. This makes the special passcodes single use only.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

refai 12 Mar 2025 | 09:20:49

thank

Secutron MR-2900 Betreibershandbuch Seite 15